LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 ((Antilock Brake System (Abs) - Electrical Diagnostics)) >> DTC Troubleshooting >> U1104-Can C Bus CRC Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY DTC IS ACTIVE 

  1. Turn the ignition on.
  2. With the scan tool, read and record the ABS DTCs.
  3. With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
  4. With the scan tool, erase the ABS DTCs.
  5. Cycle the ignition switch.
  6. With the scan tool, read the ABS DTCs.

    Does this DTC reset?

    Yes 

    • Replace the Dynamics Sensor in accordance with the Service Information.
    • Perform ABS the VERIFICATION TEST. Refer to STANDARD PROCEDURE .

    No 

    • The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched or partially broken wires.
    • Perform the ABS-INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals