Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR A DTC C1210-G SENSOR INPUT CIRCUIT PERFORMANCE

NOTE:

This DTC must be active for the results of this test to be valid.

Turn the ignition on.
With the scan tool, read and record DTCs.
With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.
With the scan tool, erase DTCs.
Cycle the ignition switch from off to on.
With the scan tool, read and record DTCs.
Does the scan tool display: C1210-G SENSOR INPUT CIRCUIT PERFORMANCE?

Yes
- Replace the Dynamics Sensor in accordance with the Service Information.
- Perform ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Perform the ABS-INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .