LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 ((Electronic Shift Module (ESM) - Electrical Diagnostics)) >> DTC Troubleshooting >> P2779-AUTOSTICK Downshift Switch Circuit Performance >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

When the expected switch state is not correctly sensed by the Shift Lever Assembly (SLA) Electronic Shift Module (ESM). If the upshift switch signal is detected as active in gear position other than drive or both upshift and downshift signals are active at the same time.

scientia non olet · About LEMON Manuals