LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 ((Electronic Shift Module (ESM) - Electrical Diagnostics)) >> DTC Troubleshooting >> P0931-BTSI Control Circuit High >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
ENGINE BRAKE DTCS PRESENT
ABS DTCS PRESENT
(L51) BRAKE SWITCH SIGNAL OPEN
(L51) BRAKE SWITCH SIGNAL SHORTED TO VOLTAGE
SHIFT LEVER ASSEMBLY

Always perform the NAG1 Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to STANDARD PROCEDURE .

scientia non olet · About LEMON Manuals