Bulb - Single Lamp
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Insert the tip of a small flat-bladed screwdriver into the notch (1) on one side of the dome lamp bezel between the lens and the lamp housing.
- Gently pry the notched edge of the lens downward until it unsnaps from the housing.
- Swing the notched end of the lens downward far enough to access the bulb (2).
- Carefully unsnap the bulb from the two bulb holders within the dome lamp housing.