Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
NOTE:
Diagnose and repair any ETC, MAP Sensor, VSS, or 5-Volt supply circuit DTCs before continuing.
1. Start the engine and allow it to reach normal operating temperature.
  WARNING:
  When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
2. Using the scan tool, select View DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2
  No
  - Perform the CHECKING FOR AN INTERMITTENT DTC diagnostic procedure. Refer to INTERMITTENT CONDITION .
VACUUM LEAK
NOTE:
This DTC is enabled on engines equipped with a plastic intake manifold to limit engine operation if a large vacuum leak should occur.

NOTE:
A large vacuum leak is the most probable cause of this DTC.
1. Inspect the intake manifold, power brake booster, and PCV system for any vacuum leaks.
2. Inspect the MAP Sensor and Throttle Body for proper installation.
3. Inspect the engine for any mechanical conditions that can cause low engine vacuum.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the PCM VERIFICATION Test. Refer to POWERTRAIN VERIFICATION TEST . .
  No
  - Go To 3
MAP SENSOR OPERATION
1. Start the engine.
2. With a scan tool, monitor the MAP Sensor voltage.
3. Snap the throttle.
  Does the MAP Sensor voltage vary from below 2.0 Volts at idle to above 3.5 Volts at wide open throttle?
  
  Yes
  - Go To 5
  No
  - Go To 4
MAP SENSOR
1. Turn the ignition off.
2. Disconnect the MAP Sensor harness connector.
3. Disconnect the PCM harness connector.
4. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the MAP Sensor and the Powertrain Control Module (PCM).
5. Look for any chafed, pierced, pinched, or partially broken wires.
6. Look for broken, bent, pushed out or corroded terminals.
7. Check each of the MAP Sensor circuits for high resistance or a shorted condition.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the PCM VERIFICATION Test. Refer to POWERTRAIN VERIFICATION TEST . .
  No
  - Replace the MAP Sensor.
  - Perform the PCM VERIFICATION Test. Refer to POWERTRAIN VERIFICATION TEST . .
POWERTRAIN CONTROL MODULE (PCM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the MAP Sensor and the Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the PCM VERIFICATION Test. Refer to POWERTRAIN VERIFICATION TEST . .
  No
  - Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information.
  - Perform the PCM VERIFICATION Test. Refer to POWERTRAIN VERIFICATION TEST . .