Right-Hand-Drive - 2.0L Diesel Engine
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface that can possibly damage the hoses.
- Using a lint free towel, wipe clean the open power steering hose end and the power steering gear port. Replace any used O-rings with new. Lubricate the O-ring with power steering fluid.
- Install the power steering pressure hose into the engine compartment from below.
- Install the pressure hose at the gear. Tighten the tube nut (2) to 32 N.m (24 ft. lbs.).
- Lower the vehicle.
- Install the pressure line (3) at the pump pressure port (4). Tighten the tube nut to 32 N.m (24 ft. lbs.).
- Install the pressure line routing bracket bolt (2) to the upper mount (7). Tighten the bolt to 24 N.m (18 ft. lbs.).
- Fill and bleed the power steering system. Refer to STANDARD PROCEDURE .
- Check for leaks.
- Install the engine appearance cover.