Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
3. Operate the Driver Window up and down several times.
4. Wait 30 seconds.
5. With the scan tool, read DDM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE DRIVER WINDOW MOTOR
1. With the scan tool, erase the DTCs.
2. Turn the ignition off.
3. Disconnect the Driver Window Motor harness connector.
4. Turn the ignition on.
5. Operate the driver window switch up and down several times.
6. With the scan tool, read DDM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Replace the Driver Window Motor in accordance with the Service Information. Refer to MOTOR, WINDOW REGULATOR, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (Q305) DRIVER WINDOW HALL SENSOR SUPPLY CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the Driver Door Module C4 harness connector.
3. Check for continuity between Ground and the (Q305) Driver Window Hall Sensor Supply circuit at the Driver Door Module C4 harness connector.
  Is there continuity between Ground and the (Q305) Driver Window Hall Sensor Supply circuit?
  
  Yes
  - Repair the (Q305) Driver Window Hall Sensor Supply circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Driver Door Module in accordance with the Service Information. Refer to MODULE, DOOR, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .