Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC NOTE:
For vehicle communication problems, use the scan tool to refer to the Network Review Screen. The screen depicts a high level view of the vehicle network. Fault and problem areas appear in red. Selecting any of the network components allows access to the source of the problem.
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.NOTE:
It may be necessary to drive the vehicle to meet the conditions to set this DTC, try to repeat the conditions in which the fault originally set by reviewing the Freeze Frame data.
Is the DTC active or pending?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION . .
- INTELLIGENT BATTERY SENSOR CIRCUIT DTCS SET IN THE BODY CONTROL MODULE
Are any Intelligent Battery Sensor Circuit DTCs set in the Body Control module?
Yes
- Diagnose the appropriate Intelligent Battery Sensor Circuit DTC in the Body Control module. Refer to B2193-00-INTELLIGENT BATTERY SENSOR INTERNAL .
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST . .