2.0L/2.4L Engine

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before proceeding, refer to WARNING .

Fig 1: Pressure Hose

Courtesy of CHRYSLER GROUP, LLC

Siphon as much fluid as possible from the power steering fluid reservoir.
Remove the engine appearance cover.
Remove the pressure hose (3) at the pump pressure port (5).
Remove the pressure hose routing bracket bolt (2) at the upper mount (8).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 2: Return Hose At Return Tube
Courtesy of CHRYSLER GROUP, LLC
Remove the return hose (1) at the return tube (2) and allow any fluid in the hose to drain. If equipped with a screw-clamp, be sure to save the original clamp for reinstallation.

Fig 3: Pressure Hose & Routing Clamp Screw
Courtesy of CHRYSLER GROUP, LLC
Remove the routing clamp screw (1) securing the pressure hose (2) to the right side of the crossmember (3).

Fig 4: Pressure Hose, Return Hose & Tube Nuts
Courtesy of CHRYSLER GROUP, LLC
Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.

Fig 5: Power Steering Hose Routing Clamps & Screws
Courtesy of CHRYSLER GROUP, LLC
Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember (3).
Remove the power steering pressure hose from the vehicle.