3.6L Engine

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressure Hose, Return Hose & Tube Nuts

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface that can possibly damage the hoses.

Install the pressure hose tube (4) at the gear. Tighten the tube nut (3) to 32 N.m (24 ft. lbs.).

Fig 2: Power Steering Hose Routing Clamps & Screws
Courtesy of CHRYSLER GROUP, LLC
Position the power steering hose routing clamps (2) on the crossmember. Install and tighten the screws to 8 N.m (71 in. lbs.).

Fig 3: Hose Fitting & Pump
Courtesy of CHRYSLER GROUP, LLC
Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with new. Lubricate the O-ring with clean power steering fluid.
Install the pressure hose (2) at the pump pressure port. Tighten the tube nut to 32 N.m (24 ft. lbs.).
Lower the vehicle.
Fill and bleed the power steering system. Refer to STANDARD PROCEDURE .
Check for leaks.