2.0L Diesel Engine

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface that can possibly damage hoses.

Fig 1: Pressure Hose, Return Hose & Tube Nuts

Courtesy of CHRYSLER GROUP, LLC

Install the pressure hose tube (4) at the gear. Tighten the tube nut (3) to 32 N.m (24 ft. lbs.).

Fig 2: Power Steering Hose Routing Clamps & Screws
Courtesy of CHRYSLER GROUP, LLC
Position the power steering hose routing clamps (2) on the crossmember. Install and tighten the screws to 8 N.m (71 in. lbs.).

Fig 3: Pressure Hose & Routing Clamp Screw
Courtesy of CHRYSLER GROUP, LLC
Position the power steering hose (2) routing clamp at the right side of the crossmember (3). Install and tighten the routing clamp screw (1) to 8 N.m (71 in. lbs.).
Install the belly pan below the engine.

Fig 4: Return Hose At Return Tube
Courtesy of CHRYSLER GROUP, LLC
Install the return hose (1) at the return tube (2) and install the clamp. If a screw-clamp is used, tighten it to 2.5 N.m (20 in. lbs.).
Lower the vehicle.

Fig 5: Removing/Installing Pressure Hose At Pump Pressure Port - Diesel Engine
Courtesy of CHRYSLER GROUP, LLC
Install the pressure line (3) at the pump pressure port (4). Tighten the tube nut to 32 N.m (24 ft. lbs.).
Install the pressure line routing bracket bolt (2) to the engine mount (7). Tighten the bolt to 24 N.m (18 ft. lbs.).
Fill and bleed the power steering system. Refer to STANDARD PROCEDURE .
Check for leaks.
Install the engine appearance cover.