LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Removal >> 2.4L >> Cylinder Block Mounted

Cylinder Block Mounted

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ECT Sensor
GC0128547Courtesy of CHRYSLER GROUP, LLC
1 - ECT
  1. Disconnect and isolate the negative battery cable.
  2. Drain the cooling system Refer to STANDARD PROCEDURE .
  3. Disconnect the Engine Coolant Temperature (ECT) sensor wire harness connector (1).
  4. Remove the ECT sensor.
scientia non olet · About LEMON Manuals