LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Removal >> 2.4L >> Coolant Adapter Mounted

Coolant Adapter Mounted

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ECT Sensor & Coolant Adapter - Gas Engine
GC0128548Courtesy of CHRYSLER GROUP, LLC
1 - ETC
2 - COOLANT ADAPTER
  1. Disconnect and isolate the negative battery cable.
  2. Drain the cooling system. Refer to STANDARD PROCEDURE .
  3. Disconnect the Engine Coolant Temperature (ECT) sensor wire harness connector.
  4. Remove the ECT sensor (1).
scientia non olet · About LEMON Manuals