LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Engine Cooling System) >> Accessory Drive >> Belt, Serpentine >> Removal >> 2.0L Diesel

2.0L Diesel

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the tire and wheel assembly.
    Fig 1: Inner Fender Splash Shield
    GC0147832Courtesy of CHRYSLER GROUP, LLC
  4. Remove the inner fender splash shield (1).
    Fig 2: Lower Splash Belt Shield
    GC0147833Courtesy of CHRYSLER GROUP, LLC
  5. Remove the lower splash belt shield (2).
    CAUTION:

    Do not allow the tensioner to snap back to the unloaded position. Damage to the tensioner may occur.

    Fig 3: Belt Tensioner & Accessory Drive Belt
    GC0147834Courtesy of CHRYSLER GROUP, LLC
  6. Using a wrench, rotate the belt tensioner (8) until the locking pin can be installed.
  7. Remove the serpentine belt (5).
scientia non olet · About LEMON Manuals