LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Exhaust System) >> Pipe, Exhaust CROSSUNDER >> Installation >> 2.0L Diesel

2.0L Diesel

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: DPF Flange, Gasket, Exhaust Crossunder Pipe & Fasteners
GC0147567Courtesy of CHRYSLER GROUP, LLC
  1. Position new gasket (3) onto the diesel particulate filter (DPF) flange (2).
  2. Position the cross-under pipe (5) into its position onto the DPF flange (2).
  3. Install the front flange mounting nuts (4). Tighten nuts to 27 N.m (250 in. lbs.).
  4. Install the rear flange bolt (5). Tighten bolt to 30 N.m (22 ft. lbs.).
    Fig 2: Clamp, Down Pipe & Cross-Under Pipe
    GC0147844Courtesy of CHRYSLER GROUP, LLC
  5. Install the down pipe (1) onto the cross-under pipe (3). Tighten the pipe clamp (2) to 50 N.m (37 ft. lbs.).
  6. Check for clearance of the exhaust to body.
    Fig 3: Engine Belly Pan & Fasteners
    GC0147566Courtesy of CHRYSLER GROUP, LLC
  7. If equipped, install the lower engine bellypan shield.
  8. Lower the vehicle.
  9. Connect the negative battery cable.
scientia non olet · About LEMON Manuals