Unit, Front Lamp: Removal: Lamp
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Loosen the front fascia on the same side of the vehicle as the front lamp unit being removed. Refer to FASCIA, FRONT, REMOVAL .
- Remove the four plastic push-pin fasteners that secure the upper grille to the Front End Module (FEM).
- Flex the fascia and grille (1) outward far enough to access and remove the three screws (2) that secure the front lamp unit to the FEM.
- Pull the front lamp unit away from the FEM far enough to access and disconnect the headlamp and dash wire harness connectors from the back of the lamp housing.
- Remove the front lamp unit from the vehicle.