LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Lamps/Lighting - Exterior (Service Information)) >> Unit, Front Lamp >> Removal >> Bulbs >> Position Lamp

Position Lamp

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The following procedure applies only to vehicles manufactured for certain export markets. Vehicles manufactured for domestic markets do not have a position lamp bulb, socket or wiring provided in the front lamp unit.

  1. Disconnect and isolate the battery negative cable.
  2. Disconnect the wire harness connector from the connector receptacle integral to the position lamp bulb socket (3) on the back of the front lamp unit housing.
  3. Firmly grasp the position lamp bulb socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
  4. Pull the socket and bulb straight out from the keyed opening in the housing.
  5. Pull the base of the bulb straight out of the socket.
scientia non olet · About LEMON Manuals