Lamp, Side Repeater: Removal: Bulb
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Side repeater lamps are used only on vehicles manufactured for certain export markets where they are required.
- Disconnect and isolate the battery negative cable.
- Remove the side repeater lamp from the fender mounting hole, but do not disconnect the wire harness connector. Refer to LAMP .
- Firmly grasp the bulb socket (1) on the back of the lamp lens/housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the socket and bulb straight out from the keyed opening in the lamp housing.
- Pull the base of the bulb (3) straight out of the socket.