LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Front Half Shaft) >> Diagnosis And Testing >> Diagnosis And Testing - Half Shaft >> Clunking Noise During Acceleration

Clunking Noise During Acceleration

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSE REPAIR
Clunk/snap noise during launch or shifting into drive or reverse.
  • Loose hub nut.
  • Damaged hub splines.
  • Replace hub nut and properly tighten.
  • Replace hub bearing and half-shaft.
Clunking noise at low speed. Severely worn or damaged tripod or CV joint. Replace half-shaft.
Rattle/clunk over bumps. Grease slung around undercarriage. Loss of lube in CV joint boots. Replace half-shaft.
scientia non olet · About LEMON Manuals