LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (40TE/41TE Automatic Transmission (Service Information)) >> Diagnosis And Testing >> Hydraulic Pressure Tests >> Test Result Indications

Test Result Indications

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. If proper line pressure is found in any one test, the pump and pressure regulator are working properly.
  2. Low pressure in all positions indicates a defective pump, a clogged filter, or a stuck pressure regulator valve.
  3. Clutch circuit leaks are indicated if pressures do not fall within the specified pressure range.
  4. If the overdrive clutch pressure is greater than 5 psi in Step 4 of Test Three, a worn reaction shaft seal ring or a defective solenoid assembly is indicated.
  5. If the underdrive clutch pressure is greater than 5 psi in Step 4 of Test Two A, a defective solenoid assembly or PCM/TCM is the cause.
PRESSURE CHECK SPECIFICATIONS

Gear Selector Position Actual Gear Pressure Taps
Underdrive Clutch Overdrive Clutch Reverse Clutch Torque Converter Clutch Off 2/4 Clutch Low/Reverse Clutch
PARK PARK 0-2 0-5 0-2 60-110 0-2 115-145
0 mph *
REVERSE REVERSE 0-2 0-7 165-235 50-100 0-2 165-235
0 mph *
NEUTRAL NEUTRAL 0-2 0-5 0-2 60-110 0-2 115-145
0 mph *
LOW FIRST 110-145 0-5 0-2 60-110 0-2 115-145
20 mph #
3 SECOND 110-145 0-5 0-2 60-110 115-145 0-2
30 mph #
3 DIRECT 75-95 75-95 0-2 60-90 0-2 0-2
45 mph #
OD OVERDRIVE 0-2 75-95 0-2 60-90 75-95 0-2
30 mph #
OD OVERDRIVE WITH TCC 0-2 75-95 0-2 0-5 75-95 0-2
50 mph #
* Engine speed at 1500 RPM 
# CAUTION: Both front wheels must be turning at the same speed.