LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Base Brakes (Service Information)) >> Parking Brake >> Lever, Parking Brake >> Removal >> Hand Operated Parking Brake Lever

Hand Operated Parking Brake Lever

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Center Console
GC0128503Courtesy of CHRYSLER GROUP, LLC
  1. Remove the floor center console. Refer to CONSOLE, CENTER, REMOVAL .
  2. Manually release the parking brake cable tension. Refer to PARKING BRAKE, STANDARD PROCEDURE .
    Fig 2: Cable Mounting To Hand Lever
    GC0128496Courtesy of CHRYSLER GROUP, LLC
  3. Remove the mounting screws (3) fastening the front cable (4) to the side of the parking brake lever (1).
  4. Remove the adjusting nut (2) from the end of the front parking brake cable.
  5. Remove the cable strand from the lever.
    Fig 3: Parking Brake Indicator Lamp Switch & Connector
    GC0128511Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the wiring connector (2) at parking brake indicator lamp switch (1).
    Fig 4: Hand Lever Mounting
    GC0128512Courtesy of CHRYSLER GROUP, LLC
  7. Remove the two horizontal (5) and one vertical (2) mounting bolts, then remove the parking brake lever (1) from the shifter bracket (4).
scientia non olet · About LEMON Manuals