LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Wiper System & Washer System (Service Information)) >> Pump, Windshield Washer >> Removal >> Front And Rear

Front And Rear

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Washer Pump/Motor Housing
GC0128702Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Siphon the washer fluid from the washer reservoir into a clean container for reuse.
  3. Remove the washer reservoir from the cooling module. Refer to RESERVOIR, WINDSHIELD WASHER, REMOVAL .
  4. Pull lightly outward on the top of the washer pump/motor housing (2), away from the washer reservoir to disengage the top of the motor from the receptacle in the reservoir.
  5. Using hand pressure, firmly grasp and pull the washer pump upward far enough to disengage the pump inlet nipple from the rubber grommet seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.
  6. Remove the washer pump/motor unit from the washer reservoir.
  7. Remove the rubber grommet seal/filter screen from the washer pump mounting hole in the reservoir and discard.
scientia non olet · About LEMON Manuals