Nozzle, Washer: Removal: Headlamp
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Take proper precautions to ensure there is no cosmetic damage done to the paint finish of the headlamp washer nozzle bezel or the front fascia during the following procedure.
- Raise and support the vehicle.
- Remove the push pin retainers that secure the lower front edge of the front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
- Reach up behind the front fascia to access and securely clamp the headlamp washer supply hose to prevent the contents of the washer reservoir from draining during the following procedure.
- From behind the front fascia, depress the two integral latches (1) of the washer nozzle bezel and push the nozzle out through the face of the fascia.
- From the face of the front fascia, pull the nozzle out from the mounting hole far enough to access the headlamp washer nozzle supply hose (1) quick connect fitting (4).
- Pull the molded plastic lock (2) away from the quick connect fitting far enough to disengage the hose from the washer nozzle nipple (3).
- Remove the nozzle from the front fascia.