Nozzle, Washer: Installation: Rear
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
- Position the new rear washer nozzle (3) to the mounting hole in the liftgate outer panel (1). Be certain that the rubber gasket is in position on the back of the nozzle.
- Reconnect the washer supply hose (2) to the barbed nipple on the back of the nozzle.
- Push the hose and nozzle nipple into the mounting hole in the liftgate outer panel and align the anti-rotation tab to the mounting hole.
- Using hand pressure, push firmly and evenly on the nozzle until both integral latch features are fully engaged on the back side of the outer panel.