Erasing HOMELINK® Transceiver Codes

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Individual channels cannot be erased. Erasing the HomeLink® transceiver codes will erase ALL programmed codes.

To erase programming from all three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

Press and hold the two outer HomeLink® transceiver buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time beginning with "Programming". Refer to PROGRAMMING HOMELINK® TRANSCEIVER CODES .