LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Removal >> Liftgate Opening

Liftgate Opening

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Low Frequency (LF) Antenna, Two Screws & Two Plastic Nuts
GC0147723Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the rear fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .
  3. Disconnect the wire harness connector (4) from the connector receptacle for the Low Frequency (LF) antenna (2) on the lower liftgate opening cross member.
  4. Remove the two screws (3) that secure the LF antenna to the two plastic nuts (1) in the cross member.
  5. Remove the LF antenna from the vehicle.