Rear Floor Panel

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wire Harness Connector, Low Frequency (LF) Antenna & Rear Floor Panel

Courtesy of CHRYSLER GROUP, LLC

Check to be certain that the two plastic nuts (4) are in good condition and properly installed in the rear floor panel (1).
Raise the rear edge of the rear floor carpet far enough to position the Low Frequency (LF) antenna (5) onto the rear floor panel.
Install and tighten the two screws (2) that secure the LF antenna to the two plastic nuts in the rear floor panel.
Reconnect the wire harness connector (3) to the connector receptacle for the LF antenna.
Reinstall the second row seat cushion onto the rear floor panel. Refer to SEAT, INSTALLATION .
Reconnect the battery negative cable.