Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. Turn the Windshield Washers on and off.
3. With the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
ATTEMPT TO SET THE OPPOSITE DTC
1. Turn the ignition off.
2. Disconnect the Washer Pump Motor harness connector.
3. Turn the ignition on.
4. Turn the Front Windshield Washers on and off.
5. With the scan tool, read the DTCs.
  Does the scan tool read: B233D-13-FRONT/REAR WASHER MOTOR (+) CONTROL - CIRCUIT OPEN?
  
  Yes
  - Replace the Washer Pump Motor in accordance with the Service Information. Refer to PUMP, WINDSHIELD WASHER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (W10) FRONT WASHER PUMP MOTOR CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the BCM A harness connector.
3. Turn the ignition on.
4. Measure the voltage between ground and the (W10) Front Washer Pump Motor Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage in the (W10) Front Washer Pump Motor Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 4
CHECK THE (W10) FRONT WASHER PUMP MOTOR CONTROL CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Measure the resistance between ground and the (W10) Front Washer Pump Motor Control circuit.
  Is the resistance above 10k Ohms?
  
  Yes
  - Replace the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the short to ground in the (W10) Front Washer Pump Motor Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .