Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the ignition off.
4. Turn the ignition on to ACC.
5. With the scan tool, read DTCs.
  Does the scan tool display DTC: B2121-15-IGNITION RUN CONTROL 1 - CIRCUIT SHORT TO BATTERY OR OPEN?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE IGNITION RUN RELAY FOR CORRECT OPERATION
1. Turn the ignition off.
2. Remove the Ignition Run Relay and substitute it with a known good relay.
3. Turn the ignition on to ACC.
4. With the scan tool, read DTCs.
  Does the scan tool display DTC: B2121-15-IGNITION RUN CONTROL 1 - CIRCUIT SHORT TO BATTERY OR OPEN?
  
  Yes
  - Go To 3
  No
  - Replace the Ignition Run Relay.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (K619) IGNITION RUN RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Remove the Ignition Run Relay.
3. Using a 12-volt test light connected to ground, check the (K619) Ignition Run Relay Control circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Repair the short to voltage in the (K619) Ignition Run Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 4
CHECK THE (K619) IGNITION RUN RELAY CONTROL CIRCUIT FOR AN OPEN
1. Disconnect the BCM E harness connector.
2. Measure the resistance of the (K619) Ignition Run Relay Control circuit between the Junction Block and the BCM E harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the open in the (K619) Ignition Run Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .