LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Tires & Wheels (Service Information)) >> Removal >> Steel Wheel

Steel Wheel

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle so that tire and wheel assembly clears ground level. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 1: Tire & Wheel Mounting
    GC0082325Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    When removing the bolt-on wheel cover, do not attempt to pry the wheel cover off the wheel. It is held on by the wheel mounting nuts.

  2. Remove the five wheel mounting (lug) nuts (3) from the wheel studs. While removing the nuts, hold the wheel cover (2) in place so it doesn't fall off when the last nut is removed.
  3. Remove the wheel cover (2) using care not to let the tire and wheel assembly (1) fall off the vehicle.
  4. Remove the tire and wheel assembly (1) from the hub.
scientia non olet · About LEMON Manuals