Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- Cycle the ignition from off to on.
- With the scan tool, read TPM DTCs.
Is the DTC active?
Yes
- Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
- Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE .