LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Vehicle Theft Security (Service Information)) >> Sensor, Intrusion Module >> Installation >> Third Row

Third Row

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Second Row Seating Overhead Lamp & Retainer Lever
GC0158495Courtesy of CHRYSLER GROUP, LLC

The third row intrusion module sensor is attached to the third row seating overhead lamp retainer lever and is available for separate service replacement.

  1. Position the intrusion module sensor close enough to the headliner overhead lamp opening to access and reconnect the sensor pigtail wire to the jumper wire harness above the headliner.
  2. Position the intrusion module sensor transducer to the receptacle on the inside surface of the overhead lamp retainer lever (2) and rotate it clockwise about 30 degrees to engage it with the receptacle.
  3. Reinstall the third row seating overhead lamp (1) to the headliner. Refer to LAMP, DOME, READING, INSTALLATION .
  4. Reconnect the negative cable to the battery.
scientia non olet · About LEMON Manuals