LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Front Half Shaft) >> Diagnosis And Testing >> Diagnosis And Testing - HALFSHAFT >> Noise Or Vibration In Turns

Noise Or Vibration In Turns

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Vibration associated with the CV joints in the halfshafts occur in the 3rd and 8th order. Use a vibration analyzer to determine the frequency of the vibration.

SYMPTOM POSSIBLE CAUSE REPAIR
Clicking noise while turning. Lack of lube in CV joint boots. Replace halfshaft
Chuckling or snap noise while turning. Loose wheel or hub nut. Tighten wheel or hub nut. Replace damaged components.
Loud knocking noise centering on inner CV tripod joints. Damaged Differential side/pinion gears. Remove halfshaft and rotate side gears by hand. Replaced damaged transaxle components.

Noise may also be caused by another component of the vehicle coming in contact with the half shaft, brake or wheel assemblies.

scientia non olet · About LEMON Manuals