LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Front Half Shaft) >> Diagnosis And Testing >> Diagnosis And Testing - HALFSHAFT >> Clunking Noise During Acceleration

Clunking Noise During Acceleration

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSE REPAIR
Clunk/snap noise during launch or shifting into drive or reverse.
  1. Loose hub nut.
  2. Damaged hub splines.
  1. Replace hub nut and properly tighten.
  2. Replace hub bearing and halfshaft.
Clunking noise at low speed. Severely worn or damaged tripod or CV joint. Replace halfshaft.
Rattle/clunk over bumps. Grease slung around undercarriage. Loss of lube in CV joint boots. Replace halfshaft.
scientia non olet · About LEMON Manuals