LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Ignition System (Service Information)) >> Sensor, Camshaft Position >> Removal >> 2.4L 1/1 Exhaust

2.4L 1/1 Exhaust

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Cam Sensor Shield Installed
GC0082376Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the Camshaft Position (CMP) sensor wire harness connector.
  3. Remove the heat shield retaining nut.
    Fig 2: Rear Cam Sensor Shield Removed
    GC0082377Courtesy of CHRYSLER GROUP, LLC
  4. Pull the heat shield out to uncover the CMP sensor.
  5. Remove the CMP sensor mounting stud-bolt.
    Fig 3: Cam Sensor
    GC0082375Courtesy of CHRYSLER GROUP, LLC
  6. Remove the CMP sensor.
scientia non olet · About LEMON Manuals