Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read DTCs and record on the repair order.
3. With the scan tool, record and erase DTCs.
  WARNING:
  To avoid possible serious or fatal injury, check brake capability is available before road testing.
4. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
5. Park the vehicle.
6. With the scan tool, read ABS DTCs.
  Is this DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the ABS-INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Replace the Dynamic Sensor in accordance with the Service Information. Refer to SENSOR, DYNAMICS, REMOVAL .
2. Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
3. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
4. With the scan tool, read the DTCs.
  Does the DTC remain still active?
  
  Yes
  - Replace the Anti-Lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.