LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Heating & Air Conditioning (Service Information)) >> Plumbing, Front >> Standard Procedure >> Refrigerant System Charge >> Charging Procedure

Charging Procedure

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the safety precautions and warnings in this Service Information before performing this procedure. Failure to follow these instructions may result in serious injury or death.

CAUTION:

A small amount of refrigerant oil is removed from the A/C system each time the refrigerant system is recovered and evacuated. Before charging the A/C system, you MUST replenish any oil lost during the recovery process. See the equipment manufacturer instructions for more information.

  1. Recover and evacuate the refrigerant system. Refer to PLUMBING, FRONT, STANDARD PROCEDURE .
  2. Connect an R-134a refrigerant recovery/recycling/charging station that meets SAE standard J2788 to the refrigerant system.
  3. When required, adjust the refrigerant oil level. Refer to OIL, REFRIGERANT, STANDARD PROCEDURE .
    NOTE:

    A/C system refrigerant capacity can be found on the HVAC Specification Label, located in the engine compartment.

  4. Measure the proper amount of refrigerant and heat it to 52° C (125° F) with the charging station. Refer to REFRIGERANT, SPECIFICATIONS . See the operating instructions supplied by the equipment manufacturer for proper use of this equipment.
  5. Open both the low and high side valves, then open the charge valve to allow the heated refrigerant to flow into the refrigerant system.
  6. When the transfer of refrigerant has stopped, close the valves.
    WARNING:

    Take care not to open the high side (high pressure) valve while performing Step 7. Failure to follow these instructions may result in possible serious or fatal injury.

  7. Perform the following if all of the refrigerant charge did not transfer from the dispensing device:
    • Open all of the windows in the vehicle.
    • Set the heating and A/C system so that the A/C compressor is operating and the blower motor is operating at its lowest speed setting.
    • Run the engine at a steady high idle (about 1400 RPM).
    • If the A/C compressor does not operate, test the compressor control circuits and repair as required.
    • Open the low side valve and the charge valve to allow the remaining refrigerant to flow into the refrigerant system.
    • When the transfer of refrigerant has stopped, close the valves.
  8. Disconnect the refrigerant recovery/recycling/charging station from the refrigerant system service ports.
  9. Reinstall the caps onto the refrigerant system service ports.
scientia non olet · About LEMON Manuals