Compressor Oil Drain Procedure - Fixed Displacement
WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be certain to adjust the refrigerant system oil level when replacing an A/C compressor. Failure to properly drain and measure the refrigerant oil from the A/C compressor can prevent the A/C system from operating as designed and cause serious compressor damage.
The Denso fixed displacement A/C compressors are filled with refrigerant oil from the factory. Use the following procedure to drain and measure refrigerant oil from the Denso fixed displacement A/C compressors.
- Position the original A/C compressor so that the refrigerant oil can drain out of the suction and discharge ports into a suitable clean measured container. Hold the original A/C compressor in this position until all of the refrigerant oil is drained from the compressor.
- Drain all of the refrigerant oil from the replacement A/C compressor into a clean measured container.
- Refill the replacement A/C compressor with the same amount of refrigerant oil that was drained out of the original compressor. Use only clean refrigerant oil of the type recommended for the A/C compressor in the vehicle.
CAUTION:
Failure to properly adjust the refrigerant oil level prior to installation of a replacement compressor can prevent the A/C system from operating as designed and cause serious compressor damage. Refer to COMPRESSOR, A/C, INSTALLATION .