LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Heating & Air Conditioning (Service Information)) >> Distribution, Front >> Outlet, Air, Front >> Removal >> Beverage Cooler >> Cold Air Supply Hose

Cold Air Supply Hose

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cold Air Supply Hose, Air Inlet Housing, Air Distribution Housing & Bracket
GC0129277Courtesy of CHRYSLER GROUP, LLC
NOTE:

Illustration shown with instrument panel removed for clarity.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
  3. Remove the outer passenger side instrument panel air outlet. Refer to OUTLET, AIR, FRONT, REMOVAL  .
  4. Remove the beverage cooler outlet.
  5. Remove the beverage cooler bin. Refer to BIN, INSTRUMENT PANEL, LOWER, REMOVAL .
  6. If equipped, remove the silencer trim panel out from underneath the passenger side of the instrument panel. Refer to PANEL, SILENCER, LOWER, REMOVAL .
  7. Remove the glove box bin. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
  8. Reach up underneath the instrument panel and disconnect the cold air supply hose (1) from the passenger side of the air distribution housing (3).
  9. Working through the beverage cooler bin opening in the instrument panel, disengage the cold air supply hose from the bracket (4) located on the air inlet housing (2) and remove the hose. Note the routing of the hose and the instrument panel wiring for aid in reinstallation.
scientia non olet · About LEMON Manuals