LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Heating & Air Conditioning (Service Information)) >> Controls, Front >> Sensor, Temperature, In-Car >> Removal >> Removal

Sensor, Temperature, In-Car: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE:

Take the proper precautions to protect the face of the steering column opening cover from cosmetic damage while performing this procedure.

Fig 1: Steering Column Opening Cover, Two Screws & In-Car Temperature Sensor
GC0147648Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the steering column opening cover (3) and place it on a workbench. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  3. Remove the two screws (1) that secure the in-car temperature sensor (2) to the steering column opening cover and remove the sensor.
scientia non olet · About LEMON Manuals