Engine Mechanical Diagnostic Table

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CONDITION	POSSIBLE CAUSES	CORRECTIONS
NOISY VALVES	1. High or low oil level in crankcase.	1. Refer to STANDARD PROCEDURE .
	2. Thin or diluted oil	2. Change oil and filter.
	3. Low oil pressure	3. Check oil pump, if OK, check rod and main bearings for excessive wear.
	4. Dirt in lash adjusters	4. Replace as necessary.
	5. Worn rocker arms	5. Replace as necessary.
	6. Worn lash adjusters	6. Replace as necessary.
	7. Worn valve guides	7. Inspect the valve guides for wear, cracks or looseness. If either condition exists, replace the cylinder head. Refer to CYLINDER HEAD, REMOVAL .
	8. Excessive runout of valve seats on valve faces	8. Refer to VALVES, INTAKE AND EXHAUST, STANDARD PROCEDURE .
CONNECTING ROD NOISE	1. Insufficient oil supply	1. Refer to STANDARD PROCEDURE .
	2. Low oil pressure	2. Check oil pump, if OK, check rod and main bearings for excessive wear.
	3. Thin or diluted oil	3. Change oil and filter.
	4. Excessive bearing clearance	4. Replace as necessary.
	5. Connecting rod journal out-of-round	5. Service or replace crankshaft.
	6. Misaligned connecting rods	6. Replace bent connecting rods.
MAIN BEARING NOISE	1. Insufficient oil supply	1. Refer to STANDARD PROCEDURE .
	2. Low oil pressure	2. Check oil pump, if OK, check rod and main bearings for excessive wear.
	3. Thin or diluted oil	3. Change oil and filter.
	4. Excessive bearing clearance	4. Replace as necessary.
	5. Excessive end play	5. Check thrust washers for wear.
	6. Crankshaft journal out-of round	6. Service or replace crankshaft.
	7. Loose flywheel or torque converter	7. Tighten to correct torque.