LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System (Service Information) >> Sensor, Camshaft Position, 2.8L Diesel >> Removal >> 2.8L Diesel

2.8L Diesel

Fig 1: Camshaft Position Sensor Harness Connector, Sensor & Bolt
GC0102482Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the Camshaft Position (CMP) sensor wire harness connector (1).
  3. Clean the area at base of CMP sensor.
  4. Remove bolt (3) and the CMP sensor (2).
scientia non olet · About LEMON Manuals