Diagnostic Test

ACTIVE DTC
1. Ignition on, engine not running.
2. With the scan tool, select View DTCs.
  Is the U1418-IMPLAUSIBLE RIGHT WHEEL DISTANCE SIGNAL RECEIVED Active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
ABS MODULE IS ACTIVE ON THE CAN C BUS
1. With the scan tool, select ECU View.
2. Verify that the ABS Module is active on the bus.
  Is the ABS Module active on the bus?
  
  Yes
  - Go To 3
  No
  - Refer to DIAGNOSIS AND TESTING and perform the NO RESPONSE FROM ABS diagnostic procedure.
DTCS STORED OR ACTIVE IN THE ABS MODULE
1. Check for DTCs in the ABS Module.
  Are any DTCs active or stored in the ABS Module?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Go To 4
ACTIVE DTCS IN THE TIPM
1. With the scan tool, select ECU View and select TIPM.
2. With the scan tool, read Active DTCs.
  Are any Communication DTCs active in the TIPM relating to the ABS System?
  
  Yes
  - Replace the ABS Module in accordance with the Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module in accordance with the Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .