Patching Panels

Fig 1: Identifying Damaged Panel Cutout And Patch

Courtesy of CHRYSLER GROUP, LLC

1 - CUTOUT

2 - DAMAGED BODY PANEL

3 - 4 MM (0.160 IN.) HOLES

4 - PATCH CUT TO SIZE

A panel that has extensive puncture type damage can be repaired by cutting out the damaged material. Use a suitable reciprocating saw or cut off wheel to remove the section of the panel that is damaged. The piece cut out can be used as a template to shape the new patch. It is not necessary to have access to the back of the panel to install a patch. Bevel edges of cutout at 20° to expose a larger bonding area on the outer side. This will allow for an increased reinforcement areas.