Bezel, Instrument Cluster: Removal: Removal

Fig 1: Two Retaining Clips & Steering Column Opening Cover

Courtesy of CHRYSLER GROUP, LLC

Remove the HVAC outlet (1). Refer to OUTLET, AIR, REMOVAL .
Position the steering wheel into the full down position.
Remove the steering column opening cover (3). Refer to COVER, STEERING COLUMN OPENING, REMOVAL .

Fig 2: HVAC Outlets
Courtesy of CHRYSLER GROUP, LLC
Remove the two center HVAC outlets. Refer to OUTLET, AIR, REMOVAL .

Fig 3: Instrument Cluster Bezel & Switch Assembly
Courtesy of CHRYSLER GROUP, LLC
If equipped with power windows, using a (special tool #C-4755, Trim Stick) or a suitable flat bladed tool, gently pry the switch assembly (2) away from the instrument cluster bezel (1).
For vehicles without power windows, using a (special tool #C-4755, Trim Stick)or a suitable flat bladed tool, gently pry the storage bin assembly away from the bezel and remove.
Disconnect the switch assembly electrical connector and remove the switch.

Fig 4: Top Screw
Courtesy of CHRYSLER GROUP, LLC
Remove the storage bin mat and remove the top screw (1).
Remove the screw (2) from the switch opening.
Remove the screws (3).

Fig 5: Vent Openings, Lower Bezel & Lower Retaining Clips
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Do not use tools to release the lower bezel retaining clips or damage to the bezel and reinforcment ring can occur.
Without the use of tools reach into the IP cavity through the vent openings (1) and firmly grasp the lower bezel (2) behind the bezel reinforcement ring and carefully pull the bezel back to release the lower retaining clips (3).

Fig 6: Retaining Clips & Bezel
Courtesy of CHRYSLER GROUP, LLC
Release the remaining 13 retaining clips (1) and remove the bezel (2).
Disconnect the power window switch electrical connector, if equipped.