Repair Procedure For B-Pillar MUCKET

This repair procedure is applicable when water is evident on the: 

Fig 1: B-Pillar Trim

Courtesy of CHRYSLER GROUP, LLC

• B-pillar trim or seat

Fig 2: Bad Mucket

Courtesy of CHRYSLER GROUP, LLC

1. Inspect the mucket for a rolled under condition (1).
2. Inspect the mucket for a missing drain hole (2).
3. If either of these conditions exist, replace the mucket detail.
   Fig 3: Good Mucket

   Courtesy of CHRYSLER GROUP, LLC
4. Reinstall the panel or side rail making sure not to distort the mucket (1).

The header seal mucket (1) installed correctly, will appear as this - 

Fig 4: Freedom Panel

Courtesy of CHRYSLER GROUP, LLC

1. Inspect Freedom Panel for damaged or missing foam.
2. If the foam is damaged or missing, replace the foam using the Foam Kit available through Mopar Parts.
   Fig 5: Foam & Panel

   Courtesy of CHRYSLER GROUP, LLC
   NOTE:

   This foam (3) is in addition to the foam (2) that is already on the panel (1)

3. Add an additional piece of foam (3) to the freedom panel as shown This foam can be created by cutting the 30 x 75mm GREY foam in half, from the Foam Kit.