Diagnostic Test

CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNAL 

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Freeze Frame information.
4. With the scan tool, erase DTCs.
   WARNING:

   Make sure brake capability is available before road testing.

5. Start the vehicle and turn the wheel from lock to lock.
6. Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph).
7. Park the vehicle.
8. With the scan tool, read and record DTCs.

   Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL?

   Yes 

   • Replace the Clockspring in accordance with the Service Information. The Steering Angle Sensor is internal to the Clockspring.
   • Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .

   No 

   • Perform the ABS INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .