Diagnostic Test

CHECK FOR A DTC C1232-DRIVE TEST: PRESSURE SENSOR
NOTE:
This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.
4. Perform ECU initialization with drive test. Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
5. Start the engine and apply the brake firmly.
6. With the scan tool, read and record DTCs.
  Does the scan tool display: C1232-DRIVE TEST: PRESSURE SENSOR?
  
  Yes
  - Go To 2
  No
  - Perform the ABS-INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .
CHECK HYDRAULIC SYSTEM AND BRAKE SYSTEM COMPONENT INSTALLATION AND FUNCTION
1. Verify that the Anti-Lock Brake Module and Hydraulic Control Unit are properly installed.
2. Verify that the hydraulic system is properly filled and bled.
3. Verify that the brake system components are installed and functioning properly.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Clean contacts in HCU first if problem reoccurs replace the Integrated Control Unit in accordance with the Service Information.
  - Perform ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .