LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Pads And/Or Shoes, Brake >> Installation >> Front Pads

Front Pads

Fig 1: Caliper Adapter Mounting Bolts, Inboard/Outboard Brake Pads & Caliper Adapter
GC0130655Courtesy of CHRYSLER GROUP, LLC
  1. Remove and clean all rust and debris from the anti-rattle clip mounting surfaces (3) on the brake caliper adapter (2).
  2. Install new anti-rattle clips into the caliper adapter (4).
  3. Install the inboard (2) and outboard brake pads (3) onto the caliper adapter (4).
    Fig 2: Identifying Disc Brake Caliper & Components
    GC0130323Courtesy of CHRYSLER GROUP, LLC
  4. Install caliper (4) on the caliper adapter.
  5. Install the caliper slide pin bolts (3) and tighten to 44 N.m (32 ft. lbs.).
  6. Install wheel and tire assembly.
  7. Remove support and lower vehicle.
  8. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.
  9. Fill brake fluid.
scientia non olet · About LEMON Manuals